Lavender Valley's latest activity
-
LThat is what is referred to as a normal DIY oil change. FYI, do yourself a favor, get a metal drain pan, I refuse to use plastic pans...
-
LLavender Valley replied to the thread Gambled on a G5200 Today.I would remove the injectors and glow plugs and have them checked and serviced.
-
LLavender Valley reacted to 4570Man's post in the thread I Went To Purchase A New Mini-Excavator And This Happened..... with
Good Post.
That just looks like dirt from sitting outside on the dealers lot for a couple months to me. They could have used a power washer on that... -
LLavender Valley reacted to dusty3030's post in the thread I Went To Purchase A New Mini-Excavator And This Happened..... with Good Post.
It’s been sitting outside for a long time for sure. Nothing is gouged below air cleaner that’s a flexible heat shield / blanket it...
-
LLavender Valley reacted to scootr's post in the thread I Went To Purchase A New Mini-Excavator And This Happened..... with Good Post.
7 hours is probably 1/1000 of its useful life. I once bought a 2 yr old rental unit with 1500 hrs on it. It had dents and scratches on...
-
LLavender Valley reacted to MattB4's post in the thread I Went To Purchase A New Mini-Excavator And This Happened..... with Good Post.
I am curious why when you asked the dealer to check the hours that you did not go over the excavator yourself before you agreed to have...
-
LLavender Valley reacted to CalG's post in the thread Looking for 24mm or 15/16" pins with Good Post.
If you come by, I can turn that 1 inch pin down to any size you need on the lathe. Not a simple task, as the commercial pins don't...
-
LLavender Valley replied to the thread Not to Brag, but....I have a quick hitch, and the tractor has a hydraulic tilt and top hitch. I have modified all 8 attachments to suit the quick hitch, so...
-
LI've sold my Woods rotary cutter (brush hog), but I don't think hookup ever took me longer than 1 minute with the quick hitch, or maybe...
-
LLavender Valley reacted to tomplum's post in the thread Old Craftsman Tractor - How to Remove Pulley with Good Post.
If push comes to shove, cut the shaft off so you can work with it. Heat / press etc.
-
LLavender Valley reacted to ultrarunner's post in the thread Old Craftsman Tractor - How to Remove Pulley with Good Post.
Allen Screw Deep inside the hole shown would be a common method. If it’s never been off a good penetrating oil applied ahead of time...
-
LLavender Valley replied to the thread No, I am NOT going to try to take down a dead 100' Hickory tree!.It needs to come down, you either cut that grass or have stock graze it, either way a danger to those around or under it, and it will...
-
LLavender Valley reacted to hayden's post in the thread Skidder or Tractor? If you could only have one. with Good Post.
Right, which are we talking about? A Skidder or a Skidsteer? They are two vary different machines.
-
LLavender Valley reacted to Rockbadchild's post in the thread “Forcing” the FEL to lift? with Good Post.
KWentling beat me to it but I second his comment.... utilize the tilt (bucket curl) over the lift it will be easier to lift once the...
-
LLavender Valley replied to the thread “Forcing” the FEL to lift?.All hydraulic systems have a relief valve in the hydraulic bank (where the levers are). The oil when the relief valve opens, returns to...