You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser.
-
L
lescan replied to the thread
3ph not staying up.
This was exactly the problem. By tightening the nut and the jam nut I was able to control how tight the lever is and it doesn't drop any...
-
L
lescan replied to the thread
3ph not staying up.
I’ll take a look. Thanks
-
L
lescan replied to the thread
3ph not staying up.
The only other control is the rate of drop dial under the seat. If I tighten that too much then the 3ph does not come down at all. I’ll...
-
L
The 3ph on my Massey 1528 compact tractor won’t stay up. Both the 3ph and the 3ph position control lever drop if the control lever is...
-
L
I had a similar issue with my compact tractor where low rpm was fine but brush hogging at high rpm would cause the engine to bog. Turns...
