Recent content by liberty2701

I couldn't locate one. This is a best guess.

I ordered one of these. It looks exactly like the one on the starter. We will see if it works. New Starter Solenoid For Mitsubishi 12V 16497 | eBay

Well, so much for that. It wouldn't start again. It's not the relay. The battery cables are clean. The solenoid is getting 12.6 v when turning the key to start. If I jump across the solenoid it starts right up. That tells me the solenoid is bad. Any more thoughts?

I just went to start the tractor and it did it again. I swapped the plugs on the starter relay and its started instantly. Not sure if it was coincidence or causation being the problem is intermittent anyway.

All the connections appear corrosion free from the battery to the starter. Tractor is also parked indoors. Could a starter relay allow less than full voltage to the solenoid at different times?

Hello, I have had my tractor since new and have about 800 hrs. Not one problem until now. Occasionally the starter solenoid will not engage. I verified that it is getting power when this happens, so it is the solenoid. I am having trouble locating just a solenoid. Any suggestions? Has anyone...

It turned out the male end was not allowing flow. The female end was good.

It was a bad fitting again. I didn't think it would be since I replaced all the loader quick connects 2 years ago.it seems Discount Hydraulic hose fitting quality is lacking. This is the second time I had their brand of fittings fail. Is there a brand that is of higher quality like Pioneer?

I will give that a try tomorrow and report back.

It was in neutral. The problem is not going up. It is having no power going down.

I have a 2014 Kioti dk50se. I just lost my down power on my loader. It goes down but it just wont lift the tractor. Every other position works normally. I disconnected the hoses from the loader block and reconnected with the same result's. If I disconnect the hoses and reconnect, the loader it...

I have an everything attachments landscape rake that is indestructible. When working in tight spaces and back into something I snap the tines. I have welded the broken ones with 7018 rod only to snap again. Looking at replacements. It comes with the Italian one hole tines. I see others available...

Try the Amsoil fluid. You will be very pleased. Warm up time is greatly reduced especially in the cold.

I suggest you go read about the Vostok ice cores and you will rapidly realize the whole global warming or shall I now say climate change "Agenda" is nothing more than just that. An "Agenda".

Your link did not work. Is it Curtis Hydraulics?