Just bouhgt a deere LX series brush hog that had been sitting not used outside for 2 years .
I would like to change the oil in it , it has the slip clutch.
Can anyone tell me what oil is reckomended ?
Thank you in advance , John -Lone Oak Landscaping-
Any one have any expierience with a 74 or 84 inch new holland snow blower ( I think woods makes them ) or any other brand front mounts for that matter,
would like to know how you think it works ( good ,bad or ugly any info is appericeated)
I currently have a 72 inch blade with the sub frame...
Question for TC owners - Does your temp gauge run up around the top of the normal operating range ?
Bought my TC40DA at the end of the fall last year and noticed it ran on the warm side while plowing all winter , now that it's getting warmer naturally it is running a bit higher on the gauge...
Bought a mulch kit for the deck from John deere,came with a mulch plug and two blades that bolth say RIGHT on each blade.
The owners manual says to make sure you put the mulch blades on LEFT and RIGHT sides correctly .
The instructions on the kit say nothing about LEFT or RIGHT hand blades.
Any...
The TC40DA blew fuse #2 today (safty start,fuel shutoff) and for the past few days it wont start every time I turn the key, sometimes I hear a click and then nothing .
I was thinking the saftey switch in the high - N - low was bad because I try wiggleing it back and forth , (and starts...
I have a trailer I would like to pull over the road that has a 4 -way flat plug (no trailer brakes ) my tc40da has no electric to plug it into.
Is there a kit I can buy to easily plug into the tractor wiring harness so I can run the lights and flashers on the trailer when on the road ?
I made...
TC40DA Still blowing fuse #5 even after I switched it from the 7.5 to the 10 like I read here .
When I use the cruise for about 5-10 min. the fuse pops and the battery light goes on in the dash, rabbit - turtle switch goes to turtle.
Change fuse and it is fine untill I run the cruise for a...
I know the tire threads have been beat to death here but I have to ask .
Can slime be used in a loaded tire ?
Will it still give puncture protection , even with the liquid ?
Sorry to put up another tire thread , Just so you know I have been looking back at old threads for days and could not...
Anyone have any tricks for getting traction for plowing when it gets icy ?
I have chains for the tractor but really hate putting them on and off, I was thinking of taking a cordless drill with me and putting a few ice screws in the tires here and there... but don't know if it will help much and...
I know it sounds stupid but I an having a tough time finding a place to mount my com. liscense plate on the TC40DA .
Sure could use some suggestions from ya' all on a decent soulition, I was thinking of welding a bracket to the one holding the SMV emblem and moving it to the side to muont the...
Can anyone wh has a sub-compact like a TZ 18, 22, 25 DA or a T1110 , give me thier opinion on thier machine good or bad ?
I am thinking of buying one of these in the spring .Thank you in advance.
Well I bought a TC40DA about 8 weeks ago and the dealer said to bring her back for the hydro recall when he got the parts in . I did just that about a week and a half ago and part of the deal was he said they would put the 7 ft. New Holland plow blade that I ordered on the machine for me when it...
Just wanted to say hi, and thank everyone here for the great info. which helped me greatly in my tractor purchase.
Signed -up today and am happy to have found such a great site .
I buoght a TC40DA about 7 weeks ago with 45 hrs. on it and it was sold and warranteed as new, also got a 250 TL...