LVKubota's latest activity

This thread brought back memories.....when i bought my 3301 almost 8 years ago, I was on the fence whether to buy new with the 0% down...

Wiggle, wiggle.... Cycled the PTO lever back and forth, that did it!! It was disengaged, but for whatever reason, bumped or...

I'm just guessing its one of your safety switches, but a volt/ohm meter will tell you for sure. Let us know what you find out.

Power everywhere else....all lights, including dash lights, glow plug light...etc.. So power is going through the ignition.....have to...

If this schematic is correct as you observed there is no safety switch for your clutch, however you do have a PTO, brake and seat...

So, of course, 1st thing that came to mind was battery.....it metered out @ 12.5 volts but we didn't have a load tester. So we threw a...

With smaller Kubotas (and Deeres) there is often just not quite enough voltage getting thru all the safety switches, etc. to trigger the...

Not certain how to "reset" the seat switch...but yes, the lever is permanently in the down position... Took me a minute to figure out...

I left out that I defeated the seat switch years ago....and after I jump it, the tractor stays running... But yeah, something is not...

I would look at all of the safety interlock switches first. Operate individual switches (pto, hst pedal, brake, clutch, seat) one at a...

No start on my L 3301. Last started a week or so ago at a job site....did get rained on which made me cringe since it's been a garage...