Recent content by M135

I have a Mahindra 7010 and need to adjust the clutch free travel. I basically have no free travel now. The owner’s manual is very vague other than an obscure picture and indicating it needs 1.18 - 1.57”. Does anyone have any specifics on how to do this?

My Mahindra 7010 tach/rpm meter is slow to operate during cold weather. The meter appears to run off the back of the alternator. Has anyone had this issue and how did you resolve?

Update - I found a replacement switch at AP Air Inc. The price was very reasonable.

Thanks. I did check the pressures and they are within operating range.

Thanks for the replies. The attached image shows the specs for the 201 (existing) switch. I’m a little concerned about operating the system from a jumper as the specs indicate it protects low and high pressures. Thoughts?

I have a 7010 with cab and the pressure switch on the AC drier is faulty. The existing switch is a SHIN HAN SHDP201. Does anyone know where I can find this switch or a comparable switch? I’ve attached an image of the existing switch.

I have a Mahindra 7010 and having a fuel issue where it loses fuel line pressure when its not running therefore making difficult cold starts. I can pump the hand primer pump a few times and the tractor will start when cold. There are no obvious fuel leaks. Fuel does not appear to be getting...

I have a Mahindra 7010 with a ML170 loader. The joystick for the curl up function recently became hard to operate and would not go back to the neutral position when released. The curl down function is not affected. Has anyone else experienced this issue?

I have a 7010 Mahindra and it recently started losing power and blowing blue-ish smoke after a short period of operation. I can kill the tractor, re-start and it will run fine for a few minutes. I unplugged the KSB unit and jumpered the brown wires and no change. I have ordered a new KSB...

I have a Mahindra 7010 tractor with an ML 170 loader. Hydraulics of the bucket will not hold when rolled out as when the operator would use to backdrag or smooth a pile of soil. It simply rolls the bucket back like there is no resistance and/or the hydraulics is not holding the bucket in...

I am having intermittent problems with my 3 point hitch. It will just stop working and then later it may start working. This model has the electric over hydraulic operation. Fuses and oil levels are good. Has anyone had this problem before? Thanks.

Hey all, I'm having an intermittent 3 point hitch problem. It will just stop working. This model has an electro-hydraulic operating system. Has anyone else had that problem?