Recent content by Macawake

I have found a good deal on a J.D. 660 Tiller and will use it on a Kioti DK5510. wondering if this is workable. No hard clay mostly Sandy Loam. I can't find specs on what the h.p. rating of the tiller is.

I guess a rodent chewed through the little tube on the top of the manifold of my 5510 causing me to leak diesel. I am having a hard time getting it disconnected from the tee. Is this just something that I can cut off of the tee and replace the short limb or do I need a new tee also and...

Thanks, the dealer is right around the corner from my office, so I will swing by tomorrow. Here is the Assembly diagram, and the bolt that keeps getting loose is #16. The washers (#39) are described as "Seal Bond, 3/8"" part no 103E1-C0380. When I replace those, how tight should I crank down...

I have a new DK5510 Kioti with a KL5510 loader that was installed at the dealer. A couple of times the bolt that holds the "C.O. Line" (that is what the manual calls it) that is going into the bottom of the joystick assembly has backed out causing a leak. I have tightened it pretty snug both...