I acquired a 4310 with a 48 backhoe. Was going to take it off so I got used to it on a nicer day and see how hard it is. After doing some reading on the internet I see that you are supposed to add some parts to be able to use the 3 point hitch.
Anyone know the exact parts I should be looking...
I took apart the front cowl and lubed/greased all springs and pivot points for the rear brakes that are sticking. I lubed/greased the joints and rods under the foot panel as well.
The rear brakes still sticking until 15-20 mins into use then they free up. It's bad enough that if I'm going down...
Only asking about the C Channel because I can pick that up for $5 a stick (5' already cut to length).
I took a picture of my ramps in where you can see they were bent, and I bent them back into place causing a "crease" in the sides. They were 2x2x3/16
Making a new set of loading ramps since my last set buckled under the weight of my tractor while loading it. JD4310 with 48 BH and 430 Bucket. ~ 5500#
Old ramps were 3" angle 3/16" thick.
New ramps were going to be built to same dimensions just with 1/4" stock.
But, come across some cheap C...