Finally ready to upgrade in size from my Subcompact tractor.
Looking for something the size of the Kubota B series/ JD 2000 series.
Eliminated the Kubota as the nearest dealer is too far away.
Decided on the JD2520.
Went to the very major John Deere dealer nearby and organised for them to...
If two tractors have identical peak torque but one has more power than the other is there any point in getting the tractor with more horsepower?
For example the JD 3032E has 31.4 Hp while the JD 3038E has 37 HP but they have identical peak torque.
Are those extra horses useless?
I would have...
My 2400 with only 12.5 hrs suddenly has no power. Can barely move the tractor let alone power the MMM! Was working fine until Today and then suddenly while mowing grass began to loose power. Engine sounds like it is running rough and won't rev very high.
Plenty of fuel, air filter clean as a...
Cut down a tree Today and used the 2400 FEL to dig out the root bundle.
A backhoe probably would have been the better choice but since I don't have one the FEL did the job admirably!
I have a 440lb ballast box on the back.
Mark
Australia
Hello All.
After much research I finally ordered a 2400 with FEL, MMM and post hole digger. It arrives on Sunday.:thumbsup:
One issue before it gets here: How heavy a ballast box should I be getting for the 3PH for FEL work? I have been offered a ballast box which is already weighted, with...
I am trying to find out the manufacturers recommended maximum towing capacity for the various brands of Subcut tractors.
If anyone who owns a subcut could check their owners manual and find out this figure I would be grateful (i.e. JD 2305, Kubota BX1860/2360, MF GC 2400 etc)
Thanks
Mark
Quick question for the wise.
When a manufacturer lists PTO HP is that with the tractor stationary?
Presumably the faster you drive a tractor or if you drive it up hill, more HP will be used to move the tractor and less will be available at the PTO? Is that correct thinking?
Thanks
Mark
Question to SC 2400 owners.
What is the largest Brush Hog you have used on this tractor?
Is a 4' 6" Brush Hog feasible for this tractor?
I am looking for a sub compact tractor and have started visiting dealers of the various brands.
When I mentioned to the SC 2400 salesman that I potentially...
Hello All from Australia
I have no experience with tractors and am looking at buying a sub compact tractor for my 2 acres. I have a question about rear lift capacity on the MF GC2400.
Browsing the MF website I notice that they list the GC2400 lift capacity @ 24" behind the ball ends at only...