Recent content by martin rock

Hi all, I just dismantled my carb for cleaning since it was leaking when engine off. I noticed that there was no power jet in it. Should i try to find one for it or just leave it as is? Thanks This is the jet below the nozzle.

Hi all I have put too much pressure in my rear tires and want to lower the pressure but the level of the fluid is above the stem at 12oclock, can I remove some fluid until no fluid gets out of the valve, that will permit me to lower the pressure, My concern is that If I expose the inner wheel...

Hi All My FEL is fixed at the back to the tractor axel which is good, but at the front, only 2 bolts support the angled plate (see picture). That seems to be a lot of weight for just 2 bolts. The angled plate is also bent due to too much load. The frame is not supported in the middle of the...

Hi all I want to add remote hydraulic at the back of the tractor. I already have a fel. Can I add a TEE where the fel return is already connected, and connect the new hydraulic return? Is there any other option where I could connect a return hose. What about the hex nut pointed by the red...

Hi all I have a mf135 with a FEL, I want to measure my gpm. My plan is to disconnect the return hose of the FEL from the tractor and have the oil go into a bucket to measure. My worry is that the return location (see picture) could be below the oil level in the tank . Is this possible? I could...

Hi All I have a problem starting my tractor, the problem is intermittent, It can start all day , then it just won`t start. But when it starts , it does start good . When it doesn't start, the starter will not make a sound. I can ear the solonoid switch make a tick when I turn the key to...

Hi All I want to test my pression because I want to add a new remote for a log loader that requires 2300psi and 5 gpm. I suspect I will be a little short on gpm since the tractor manual says 4.5 gpm at 1700 rpm but I think I can live will a slower speed. I already have a diverter valve on the...