There is a forklift on the front of my tractor. It is designed to lift 1 metric tonne. (1000 kilograms). It will lift almost 3 metres. It has three rams. Two for tilt and 1 for lift.
Not a very clear photo but I can take more if you are interested.
Today I removed the forklift and roll cage in preparation to clean the tractor with a high pressure water blaster. Then I'll remove all panels and move it into my workshop so I can split it to check out the clutch.
My Massey 154-4 clutch does not always release when the pedal is pressed. I have taken out all of the linkage slop and it is still the same. So I guess I have no choice but to split it and check over why. But why is it intermittently faulty and then ok. Anyone have a workshop manual for this...
Massey 154-4. These tractors seem to be a bit of an orphan. I believe them to be a Landini perhaps a 5500. Even the local tractor parts places have to be told about them. They usually have no parts manuals. I have managed to find a parts manual to down load off the internet. I'd like a workshop...