Recent content by Mikkelsen

Is there a front weight kit for the Kioti DK10 series tractor?

planning on using a 1,000# 3 point blower on a Kioti dk5510 which has a relatively short wheel base...about 6' I think. I'm thinking I'll need front weights to keep the tractor better balanced...any thoughts on how much extra front weight I might need?

Kioti lists the DK10 series as being naturally aspirated, but I've noticed a post that said it's a turbo...is it a turbo? If so, it's been three years since this motor is in production and Kioti still doesn't have it listed correctly??

Why are manufacturers not listing peak torque ratings? What RPM does a Kioti DK5510 reach peak torque?

Sometimes a higher hp engine can get better fuel economy than a smaller motor that has to work harder to do the same job. How do these motors compare? Displacement is the same for each, but burn different amounts of fuel...Will the amount of fuel burned be significantly more for the DK 5510...

So with this newer tier 4 motor, and high output for its size, what's a good operating RPM? If it's producing max output at 2600 RPM, but I don't need max output, is there a sweet spot that the tractor likes? 2000RPM? 2200 RPM? Is there a minimum that this motor prefers?

Planning to purchase a '15 or newer DK 10 series tractor. I want to put it to work and consequently I want to keep my eye on the hydraulic oil temps so I don't accidentally cook anything. What would be the best method for adding a temp gauge?

The 2015 and newer DK tractors are a bit smaller I believe...and they have a lot of lift ability with their FEL. The back of the tractor feels light without anything even in the bucket. Are there any recommended amounts of rear ballast for the three point hitch? 1200 lbs good? I want to...