Recent content by mntrails

You're looking for the speed Adjusting lever described as (2) below. Its small, tucked down on the right side of the seat way down near the level of your feet. The lever shown in the picture is maybe 1-1/2" (very approximately) in size.

Here's a picture of a couple of the additional parts needed to use that tiller on a Mitsubishi/Satoh tractor. Pictured are the front half of the drive shaft. This mates with the square shaft on the tiller and the other end goes on the native spline of the PTO (not out of a reverser box - the...

Does anyone know the size/thread type, etc for the oil drain plug of an S370D. The local auto parts places have a number of options that look like possible candidates but I've yet to have the original one with me to size a replacement properly. Does anyone know the specs? Thanks in advance!

I changed the radiator fluid last fall in my S370D (original radiator) and was plagued through the winter with a very slow leak out of the drain tube that exits by the drain cock. When the weather warmed up, I took the drain cock out and found an O ring on the end that was old and compressed...

I recently replaced both front tires on my Beaver S370D - they were mismatched. One is the original Bridgestone Rice Paddy ag tire. It is 36 years old and has some age cracking and rub marks on the inside but it was mounted 'tubeless' and held air over the winter until I took it off in May. If...

I have a 4WD S370D I picked up from my Dad a couple months back. He purchased it new in 1979 and overall, it's in good shape. I've changed all filters, fluids, fuel lines, and generally put in all the correct nuts, bolts, pins, etc. that inevitably get lost through the years and replaced with...

I'm trying to figure out if a 2305, FEL, Tiller, and box blade will fit on a 6-1/2' X 12' flatbed aluminum trailer with a GVW of 3000 lbs. The trailer weighs approx. 550 lbs. I have the following weights from specs: - 2305 - 1450 lbs. - Tiller - 321 lbs. - Box Blade - 275 lbs. If the 200CX...