Recent content by Mochi

Hi Everyone, This fuel hose connected to the tee leaks and tightening the factory clamp did not stop it. Then I discovered that the hose is collapse (see picture). What is the cause of the hose collapse? Thanks! Mochi

Thanks! What is "Push Lock" style fuel hose? Is it OK to use this "1/4inch ID SAE30R07 fuel hose push lock style" on the GC2300? I plan to install the hose on the metal Tee fitting and tighten with hose clamps. Here is link to the push lock style fuel hose...

Hi DMW, Thank you so much for the diagram and reminder about the restrictor. For the horizontal small section of braided hose (length of 70 MM or ~3 inches), can I replace with non-braided hose materials same as the vertical section with ID of 7MM (~1/4 inch ID)? Mochi

The hose appears to have this "NBR+PVC" on the side wall. Picture taken from a fuel hose that came installed on a 2004 MF GC2300.

Thank you very much! I really appreciate it. That really helps me a lot. I will buy the NAPA hose. One more question -- did you replace the short horizontal section (3 inches?) of braided fuel hose? I cannot tell if mine is leaking there or from the bolt behind it (see attached pdf). But I can...

Thank you so much for the excellent post. I can smell and see fuel along the left side of my MF GC2300 also. I plan to change the fuel hose (following your post). Can you tell me the hose size (ID, OD) that I should buy? Thanks Mochi