Thanks Folks, I thought I would have received a notification on the replies, so just checking back to update what I learned. Fortunately the loader frame data plate was still there and readable. 'MSL' was the key (and appearance). I figured out it is the 3rd of 4 (3 & 4 use the same kit, so...
Hello Folks,
One of my bucket tilt cylinders started blowing massive amounts of hydraulic fluid. When under load (down pressure) or when returning to tilted back after being under load (more like it's cleaning out that side of the piston). There are 3 'bleed' holes on the upper part of the...
I bought a manual on Ebay. It is helpful, but there is a lot to be wished for in the areas I have used (primarily hydraulic related). I had to replace a starter, which means a bunch of hydraulics gets moved. Details were 'light'.
When you look, get the part number and go to NH or Messicks...
Is it a TN70A? D? S?
At least for the electric shuttle shift the clutch lever has a massive spring to make it feel like a traditional clutch. The spring is on the clutch lever and pivot assembly below the dash.
The electric shuttle shift has an orange shifter handle. I would also inspect...
FWIW, TN55S is helpful when mentioning the S.
Don't forget to grease the Supersteer bearing and the front drive shaft slip joint. No idea on your experience, but I just added 2 remotes, replaced the lift arm pivot seals and torsion rod (there are more correct terms, but close enough). I see...
There's a long thread about a guy replacing his master cylinders (yes, 2 of them) in here.
No DEF on these tractors. Thankfully. Computerized, but only mechanical fuel injection.
I have an old IH. At least you can parts for yours (fortunately I only need to order a set of hammers and U bolts, should be able to use another brand).
The Operators manual may be the place you have to go. I did some repairs and added some options to my Ford/NH/Fiat. What terribly uninformative manuals.
I think you need to look around for local dealers. There are several good brands, but if you don't have any dealer near by it may matter a lot. Most/all brands in that range will require software to do more than a modest amount of work. My 1999 tractor did just to reset the clutch when a sensor...
I currently have a 55 hp tractor and a cheap Indian made 7' box scraper. Bent it excavating when I hooked roots. Stalled the tractor too. Used to have a mid 50s 21 hp Case. Bought a used 6' Gannon (Woods bought them and discontinued the line) box scraper. Always worked great (admittedly the...
Send your wife out shopping to buy new cookie sheets. Degrease it as best you can. Use the old cookie sheets under it and set the oven to 300 degrees or so (below burning the paint temperature; or clean it off first). Let it bake. Open some windows and turn on the stove hood. Accept the ass...
Ok, final part of my tractor update and repair odyssey. The 3rd function kit. I bought the one part that is NLA. The loader arm bracket for the feed through/bulkhead connectors (flat faced connector mounts). I thought I might save some money on the hoses and also make sourcing the correct (or...
Sounds like your linkage is loose, or something is slipping (maybe worn out due to being loose -- like a D or double D connection). You might want to go over the whole linkage. On mine there are external 'cams' that are large related to the draft control. Take a look at what you can find in the...
Assuming a similar system to my TN55, read the operators manual. Mine details some of the adjustments to make to keep it functioning correctly. I've not needed to adjust mine, but the adjustments look easy enough to do. I would at least look at it with the manual in hand. Mark where you started...