Recent content by moweraxle

Does anyone know what part # Gator Blade the RCK60-BX2200 mower deck uses. I hear that I need to make bushing to adapt the blade to the deck. Thanks

Time to get your anti-scalp (gauge) wheels upgraded with bronze bushings and axle bolts drilled and tapped and fitted with a grease fitting. Like to here from members that have had this done. Check out the classified ad under accessories

Tom Here is a pic of the terminal block that I used for power to my cab swich box.

Need help! A customer has a J. D. X485 with 62C deck and wants a set of mower stands. Can anyone measure with a pair of verniers the back anti-scalp wheel shaft (O.D.) And the I.D. of the tube that the shaft goes into. Thanks Larry

Just finished installing a stepvan heater (part#55-322) 15,000 BTU's $102.49 and comes with 3 speed switch. Total cost came to about $150 with fittings, hose, clamps, anti-freeze, shipping, sales tax. I removed the goose neck & thermostat & drilled & tapped 3/8" NPT in thermostat housing for my...

I have a Sims cab that I installed last winter and I would like to ad a heater (Stepvan heater pt.#55-322, $102.49) does any one know how to plumb the heater to the cooling system. Do I ad a tee fitting at the bypass hose on the water pump for the inlet feed and ad a tee fitting to the bottum...

Can any one report on the anti-scalp wheel upgrades. http://www.tractorbynet.com/forums/showflat.php? Cat=0&Board=owning&Number=487488&page=O&view=collapsed&sb=5&o=all&fpart=4&vc=1

Don't forget to remove your mower deck belt for winter storage so it doesn't get set in one spot and cause a vibration next season. It is easy to do with Larry's mower stands, with the deck standing up vertically you can rotate the blade with one hand and pull the belt outward (off the pulley)...

Installed my HD alternator today after upgrading 3 sets of anti-scalp wheels for the guys. Install was a snap and works great, the lights seem to brighter will check out put tomorrow. Thanks to every one for the help Larry

Got my new HD alernator for my BX2200 today and I cann't read French or I think it's French. Does any one have an English copy of the instructions that I can down load. Will call my dealer tomorrow and see what they have

Faced both sides of wheel then drilled and reamed to 3/4" dia. and pressed in oil impregnated bronze bushings then line reamed bushings to the 16mm dia. the OEM size of the axle bolt. 2nd I drilled and tapped axle bolt to except a 1/4-28 thd. grease fitting and cross drilled a hole 1 1/4" from...

Has anyone with a BX 2200 w/ Cab, removed the plastic fan from the water pump and replaced it with an electric fan mounted to the radiator and wired it so you could switch it to pull or blow air. Like summer, winter settings. I am going to measure the fan dia. and check it out. The thermostat...

Sims has new cab for the BX2200 w/LA211 loader 1495.00 w no options. My dealer has one in stock with my name on it and my better half said I can have it. DOB 2/5/45 How does it compare with the Curtis! I was told the Curtis cab for the BX2200 will be 2 more months before thay can deliver one...

Has any one purchased and installed a Tiny-Tach Model DTT w/ 6mm (.236) dia. transducer. Ware did you install the transducer and how do you like it.