Recent content by Mtnmnstr

Anywhere within a 45 min drive. I'd like to be as close to Thornburg as I can. I can fly my RC airplane at the field there.

We're looking at houses to the west and south of FRD. I'll most likely toss in my XR4145 and all my equipment with my current house. I'm planning on down sizing the land from my 50 acres to maybe 2-3 acres. So my 4145 might be a little much.

Well, it's a little late now, but I never cut with out having my bucket down or my grapple. Even on fields I've done before. If I can't see the ground I don't trust what's there.

As the title asks. I'm looking at a job transfer to the Fredericksburg area. Been doing a lot of homework already. After my last work trip there I discovered I don't want anything to do with north. Thanks Gene

I have a XR4145 that I've been abusing for about 7 yrs. Been doing fair amount of maintenace as required. Recently my Fwd/Rvrs is getting stuck when I shift. I'm at a stop, clutch is in. I go to shift and the handle just flexes. After I rock back or forth it will release and I can shift. What...

I had a switch issue. I could only crank it so the 3 cyl would cycle one time and stop. then I had to reset and do it again. maybe 5-6 time before it would start. I thought it was a new safety thing, kinda. When I took it in for a major recall I asked about it. The switch was not carrying all...

So far I have use my 12". I have a 6" for my 4x4's. Anybody know about a threaded auger attachments? Not the standard square with a pin.

I just remembered I posted this question here. HERE"S THE UPDATE!!!! I spend all week end disassembling the quick connects. cleaned and reassembled. took apart the WCLong valve and checked continuity on all connections. ALL SET!!!! jump up start and mashed the button. and nothing. I hooked up...

I was thinking the same. So I did it a few times. Do these connectors go bad? Like air fittings do? rarely but sometimes.

Hey guys, This is a hydraulic issue. Jumped on my XR4140 that I put 3rd function and the AE Grapple. It's been working great for 4 years. Been having issues with disconnecting the hoses. Then I bled the pressure off and popped on. Then today I read about; turn the key on and exercise the...

I'm ready to mount light on my tractor. Where are you finding the best location with the least amount of vibrations?

I was looking for a 66' Impala , they have a good hood for making tortillas.

I found a Cart top local for $100

Over the years of bashing through the over growth, saving me from Widow Makers , I ripped the whole LS canopy off my tractor. All I got is a frame left. Any of y'all have any replacement suggestions?