Recent content by mykubota4x4

Hey all, The S70 specs calls for 700lbs for lifting & tipping load 1405lb. Op wt 2708lb, roughly 23HP engine. My question is i am only lifting it just about 1/2- 1.0ft above ground to move the skid to another place, its more like a cheating..would i be able to exceed the capacity & possibly go...

Great info, Wonder my Turf tires come in line with the R4 sidewall in comparison. Have other utility trailer, tandem trailers, now have to start paying close attention to the sidewall warnings.

Never had that idea of pin hole, may as well try to open the cluster, shouldnt be that hard..i guess.

The hour meter still works & adds up while running, I doubt if its cable inside.

Hey Folks My B3030 RPM needle got stuck at max on dial & never came back down while i tried cold starting in frigid minus 20c, It does run fine & accelerate fine & have been using it that way for over a year now. If anyone had this issue or knew whats the cause would love to get it fixed.

Yes Mine is Cab model, I was already down there & saw the drain Plug over the plate, Wondering the cost factor. In addition to the Pto gear attachment, the actuator assembly at the console(mid only, rear only/mid & rear) also need to be purchased as a package.

Thanks Rjc, Good to know, will do an enquiry to see if its a meaningful conversion.

Hey Folks Currently have a L3560 with only a rear pto, Wonder if adding a Mid pto is possible at all, is it an expensive affair if doable.? Appreciate inputs.

Hey Have a 324, with similar issue. When i ratchet down the console (both right & left) all hyd function normal. There is some play when console is down that doesnt let switch to close. I already replaced the right side roller bearing(under the console). Any thoughts to fix the play(up/down) is...

Great you were able to tackle that. I Just bought same model just a few months ago, will be using it when weather gets better.

Hey Folks, Looking for some advice or improvement suggestions for my Bobcat324, the Control lock sensor clearance when console is seated for operation seem to have developed some spacing on both sides due to the roller bearing wear out...i did replace bearing on one side of the console which...

Great info though old !! Am in the same boat. with a Danuser PHD wont go beyond 18in, will try the water trick & also inspect on the bit ends.

Turns out the right side hand control console that you push down to activate the hydraulics is the issue, there is a bit of play & the console lifts up by few mm & causes to deactivate all controls (safety switch), when pushed down it all works fine. I believe there has to be a switch under...

Thanks Will top up the hydraulics 1st things and see if the problem goes away.

Bobcat324 All hydraulics, tracks, blade dont work randomly...Any idea.? Its a nice machine with 2290 hrs & have had since begining of this year, changed engine oil, filters but didnt change the hydraulic oil as it was looking good. I did remove the nut at the muffler & saw about 10gms of carbon...