Recent content by nattynuts5886

I have a 170 allis chalmer that is rounning rough it blows withe smoke an sounds like its missing. injection pump was replaced in the spring all the injectors are rebuilt an still rouns rough an smokes any ideas?

hello i am trying to pull out injectors out of my 7030 allis chalmer and they just dont want to come out. i tried a slide hammer and dint budge them so tried a pry bar nothing, than last night i tried a shop crane and got 1 to pop out no damage done to it but it took so much preasure from the...

I have a 7040 allis chalmer and back in the fall we used it to chiesle plow and when we finished my dad went to hook the disk up when he went to back the tractor up nothing happened it didn't move. We left it go fo a day or two then started it and it went into gear as usual and we drove it to...

this is what i have done so far and was wondering what the value would be. i do not have the fenders but i have the rest of the tin.

Hello, my 7040 allis chalmer is haveing some complocations when you put it in gear it wants to stall out. It is not the clutch and was wonder what els could be wrong. I want to say it is in the trany but I'm only 14 and never worked on a auto shift transmission and was hopeing it could be...

hello, i am rebuilding a mccormic deereing 04 and replaced bearings, pistons and every thing els and put engine in frame and tryed to use a pry bar to turn the fly wheel but it wouldnt budge do you have any ides what is wrong? thanks :ashamed::confused::ashamed:

the only one i took befor i started to dismantale, i did not get a camera till to late. Do you have any advice or tips for painting?

Thank you alot you saved me a mess, i will leave the cast rough that was my main worry. would a sand blaster then filler work on tin? Here is what i have done to it, i just started a couple days ago and work on it when i can.

I am prepareing to paint a 1940s mccormick deering and i have been sand blasting it but there are still little peeks and pits and rough spots all the blasting is doing is removeing old paint and rust, so i was wondering how i could remove these little mountins and pits> I thought about touch up...

Hi, i am restoreing a 04 mccormick deering and i was wondering if any one knows where i can buy or find compleat body fenders for it? thanks

I have tried to heat them up i tried to cool them rapidly i even tried to pull them off with another tractor but they do not want to move at all any ideas will help thanks.:mad::mad:

I just rebuilt a 170 allis chalmer a couple weeks ago and the high and low clutch started to act up when the tractor is put into gear and the hand clutch is in netral it still wants to drive forward and it does the same in reverse any ideas??

Have a 7040 allis chalmer and thought the clutch was going out but then it started to work again just fine and all of the clutch and stuff is ran off of hydraulics and there was two fills on it they were both full and there was a caniester makeing a noies. We took it off and turns out it was a...

:confused::confused:i rebuilt a 170 allis chalmer, i put all new pistons, sleeves, bearings, crank and seals in. i started it an it ran for a hour or so then i turned it off and started it again and the water in the radiator came all bubling out the top. the only awnser i could think of was the...

How much would a value of a 04 mccormick deering go up if i was to add the fenders on to it??