Recent content by Natureboy

I have a 2007 X728, parked it in the garage last week after mowing, ran great. Went out today to do some yard work, turned the key-and nothing. No dash lights, no clicks and the EFI didn't power up prior to starting like it always does. Brake was on & PTO switch off, and I was in the seat...

Yesterday I got a 2007 X728 Ultimate series with 4 wheel drive, 54" deck. I have the tractor manual but no deck manual. I turned the deck knob to almost full up and raised the deck. Now I cannot turn the knob to adjust. It is stuck. I took the plastic knob off and gave it a shot of PBB, but...

I have a small welding project that needs to be completed nowhere near any type of electric source. Would running a Hobart EZ 125 mig off of a B&S 6250 surgewatt-5500 running watt generator damage either welder or generator? The Hobart runs on 110v - 20 amp circuit when used normally.

I recently invested in a new electric start gas generator (easier for the wife :thumbsup:) and transfer switch for power outages that seem to occur at the most inopportune times. It runs most of the house, well pump included. I want to have a good amount of fuel on hand for those prolonged...

I was thinking about getting one of the Easy Hitch systems from Pats, then noticed that it requires 4" of straight arm. I assume that means the straight part of the lower links that includes the ball where the pins attach. I measured my CK20 HST arms, and they are only 3" of straight material...

I want to add 2 worklights (55 watters) to the rear of my 2005 CK20 HST. I've located a pair of bullet connector wires on the right side under the fuel tank. There is no power to them when the ignition is off, and they have power when the tractor is running. Has anyone out there used these wires...

Hey everyone, I've been a member since last November, but have been "lurking" since I got my CK20 HST in 2005. This is an incredible site and has taught me alot. I have a single grease fitting underneath that sits directly to the front of the 2 fittings that are on the steering shafts. It wont...