Recent content by neopheous

I was able to get my rake on mine, but it was TIGHT.... They definitely do not swing near as wide as my 40HP tractor does. Not sure there is anything you can do about it unless someone else has come up with a way for the arms to extend wider.

Good to know, but that still is 1.5 hrs away. I just found out about 4 weeks ago The Tractor Shop in South Webster, Ohio just became a Kioti dealer, so that is only 20 min away.

Thank you.

The new one should have the water sensor on it as well. I have never see one made for the CK without it. I would double check that you got the correct replacement filter.

It appears my local dealer has went out of business and the other dealers are over an hour away and I would like to be able to source the fuel filter for my CK4010 from somewhere else if possible. Preferably a Wix or similar. Has anyone had any luck with crossing this to a more readily available...

Sounds good. I’m not in a hurry and I would spend more than 15 minutes probably hooking the trailer up, setting the ramps up, and taking them down to get it loaded, then strapped in, and then doing that again in reverse when I got on site. That’s the main reason I wanted to just drive it there...

I just purchased a new 4500z and I have about 114 acres 2 miles from my home. Has anyone trekked their Ventrac that far to mow, or do you just load it up on a trailer for anything over a couple hundred yards? My Kioti CK4010 I just drive there and back when I need to do work, but I am not sure...

6” But after finally getting time to actually take a closer look at the rim, I believe the lugs came loose and caused the blowout rather than a tire failure. It appears that the holes in 2 or 3 on the rim were worn out a little oversize.

Here is the info off the tongue..... am I reading this right that I can put a 12 or 13” tire of a 13” rim??

Ok.... Well I have a 2005 Triton trailer, aluminum frame with the marine grade plywood decking. I think it is a UT128, or similar.... but the issue is I was going on a trip that would be about 700 miles round trip, and would be hauling back about 700#'s of equipment. So before going I checked...

Has anyone had to replace one of these? If so, did you go factory or use one of the universal polyurethane ones like from Energy Suspension Parts? Here’s a pic of mine. I’ve halfway tried to pull it back over the joint but was afraid of tearing it.

Well I guess hind sights always 20/20, right? Just looked at another building - 24x30 - I had built back in 2002 and I never removed the sod on it either. If fact I don’t remember the concrete guy removing the sod from it before pouring. If he didn’t, it’s been 16 years and, knock on wood...

Some pics with the metal all finished up.

So... putting up a 24x32 pole barn and it ended up being on more of a slope than anticipated. I’m curious as to what sort of economical recommendations there would be to prep this for a concrete slab. My plans were initially to only pour a 4-5” pad using fiber infused concrete. I’m just not sure...

Hello... Have someone wanting to sell me what I think is a Case 310G, but the serial number they sent me doesn't seem to match with any years that the 310 was made, for any model. Anyone know by looking the year/model of this?