OK, great let me sink this in ,I'm a hands on guy , this sparky stuff is invisible, and taxes my brain . thanks allot for your time and expertise...gus..
timer at 0 no current at load (1) ,,, timer at 0 load (2) got current ,but when load-2 engaged there's current , L-2 goes to 0 no current . being a SPDT switch there's no line 2 . Using OHM meter @ 200ohm to ck for current , thk/u. gus.
Hello; were just finally getting rain ,and in the process of dragging out the pumps.. I am bench testing though , and not getting the results with SPDT timer .. the timer i need, needs to be open when dial is turned (no ground ) then it hits 0 it should be closed ,to ground out the points...
Lots of good input here and well thought , but i'm lost (reverse action switching ? ) SEG , GTS ignition, cube ignitions ?? I'm just a good valve lapper !! . Is the reverse action switching schematic drawing the one I should show my sparky buddy for help? thk/u. gus..
Got a SPDT timer..Might be wiring up wrong , got the V/M on buzzer
Got the SPDT timer ; Might have it wired wrong , have V/M set on buzzer, (Red on line 1) (black on NO ) as shown when timer goes 0 no buzz ? any sugg. thk/u, gus..
I am not a good "sparky" , I think I understand SPDT ,so middle is off ? and if I wire to load #1 and click sw to #1 start timer then when time is 0 the sw is open and grounds out spark plug? thk/u, gus..