Everything was fine then after I parked the tractor outside covered with a tarp for a few weeks it started fine but could not get it in gear. Shut it off and put it in first gear ant started it with the clutch pushed in and the tractor started in gear with the tractor moving. The clutch is stuck...
Just installed new set of tires from Hoye. before disengaging 4wd was easy release now it takes some extra pressure to move the leaver. I have tried changing the air pressure in the tires with some fair to poor results. currently change from forward to reverse will get pressure off. Any ideas
Hi gang
I am installing the drive shaft after the tractor removed the drive shaft spontaneously. I have repaired the drive-shaft housing and got new balls, spring and such. I have a valve spring compressor to use on the spring have read the install procedure in teh 276d manual but the...
I need the 4wd driveshaft housing (tube) for a YM2020D 2 peaces.
Relatively small busher can be runover igoing forward but when backing out can bend things. Not a problen for a 2wd but think drive shaft on a 4wd.
Ym2020d I started the tractor and raised the lift leaver and nothing happend. I tried the loader it works fine not slow looks norman. I cannot find any linkage that looks out of order. The lift leaver turns a color on a shaft going into the hydraulic control assm. The only thing I did out or the...
On my 2020d I have developed a little play in the pivot pin. Neither my parts or service manual show detail of the pivot in the fromt diff. Is the pivot lubed from the diff oil or is it a separate cavity. I was wondering if I could install a grease fitting to get some extra lube in there but I...
Thanks to all the members of the forum who correctly advised me to get a 4ft bucket for the loader on my YM2020d. A full bucket of dirt is plenty for the tractor. The rear gets a little light with a full load and without the 4wd it would be unsage on my hills. Thanks guyes.
Norm ALa
It looks like the 226d and the 2020d carry 6.00x14 and 9.5x24 ag tires. Will the turff tires and rins for a 226d work on n a 2020d. I would like to have turfs wider than the 9.5x24's.
I am ordering a Koyker 120 loader for my 2020d (no power steering) and am thinking about the 5' bucket. Will 5' bucket work ok or should I stay with the standard 4'.
I have a Ym2020d and a 1400 (60 inch) Yanmar tiller with the short Yanmar top link. If I use the shorter overrun clutch (non quickchange type) can I use the tiller without removing the clutch from the pto shaft.