Recent content by nvmyhd

I'm going to build a hydraulic top link for my soon to be delivered 4155HC but since it is a Cat 2 instead of the Cat 1 I need the measurements. Fully retracted Fully expanded Pin dia. Thanks in advance for anyone that can help.

I returned from overseas two months ago to Colorado and the weather here as help make the decision for us that sooner rather than later was the time to get a new tractor. I ended up with using the same dealer in Penrose, Co. Randy took good care of me before when I has warranty issues (minor)...

I always wanted pallet forks but good gosh these things are a must have, top of the list first thing type of attachment!! It just sucks that I only bought them because were moving in the next 2 months to Germany and I needed a way to load my 40x60 shop into a semi trailer for storage. So sadly I...

I got the hydraulic fluid and filters done. The large drain plugs require a 30 mm. I drained and replaced just shy of 10 gallons. I was surprised how the drain plugs looked. Rear plug Yes there are 2 distinct shavings on that magnet. Front plug The front axle I used a crescent wrench and...

I realized that I did not post pics of when I cleaned up my front hoses. Bought the clamps off eBay as they had free shipping and got some longer metric bolts from the local farm supply. I think in the future I will up the hose size to 1/2" to increase the flow.

I'm about to buy a John Deere 606 mower and I wondered in anyone had the tech specs on it. (deck thickness, weight, gear box HP) I'm unable to find a PDF that I don't have to pay $60 for but did find paper for $25 or more on Ebay & amazon. Technical Manual TM1394 Operator's Manual...

I've been researching if the Kubota meets GL4, and it's hard to determine. In other countries it looks like they list them as meeting GL4. But given that they most likely are manufacture in different facilities / countries I can say that its good to go. One example was the Canadian fluid is made...

Picked these up today. $1300 total. Like new both only used once.

Added Hydro top link I added a hydraulic top link to the girl tonight it took about an hour to Teflon seal, tighten all the fittings, and route the hoses. Total cost $244.64 shipped to my house from Surplus Center I have not tested it out yet but so far it looks to work pretty good. Here are...

So those that have a hydraulic top link what are the length of your hoses? I'm about to order the top link and want to order the hoses and fittings at the same time. I do not wait till it gets here and measure with old air hose. I know there will be slight differences between suppliers but they...

Found out what the 2 additional switches are on the side pillar

So I've got over 140 hours on my XR4046HC and I was driving by the LS dealer and wanted to see how the new 3cyl turbo performed compared to my 4cly NA shibaura. I did a quick test drive and found that the turbo motor was a little rougher at lower RPMs but smoothed out with a few more RPM's At my...

I needed room for my kids to stand so I removed the plastic cover/cup holder from beside the seat. But the lever attachment point for the other model types does not leave a nice flat area. So I made up a cover plate. So now one of them can stand next to me without twisting an ankle. It's not...

I removed the passenger side step and replaced it with a tool box.

When I received the tractor I removed the passenger side step first thing as it has no function since the controls are in the way for ingress/egress. I finally got around to mounting a tool box in its place. I cut apart the factory step and made some modifications. I still have to wait for the...