Offroadtek's latest activity

Since the "Float" and "Fast Dump" settings are on the two motions your having trouble slowing down, I'd bet there is still something...

That temp is showing high. Mine runs just over the bottom quarter line, up to half on a hot day. Is it boiling coolant? The gauges can...

I worked on mine over 18 years ago and I've slept since then, I'm 70 years old and my memory isn't quite as good as it used to be ! Like...

With the cap and sleeve off will the lever move freely? Just need to make sure it's the sleeve restricting it and not something in the...

I was able to figure this out. While it would have been much easier to have had smaller hands I removed the 2 black Phillips screws...

Ok. Then assuming someone didn’t switch the sleeves up in the past, the groove should go up. I saw the fast dump option on your diagram...

Those are a little gummed up. Break all that free and it should work better. I think the step would go down so it holds the lever at...

Try this site and search model "ml108h". It's got a lot of exploded diagrams of your valve...

OK, those caps are the same length because you should have the detent setting to the top and to the right. If it does not want to go...

I'm thinking the same thing from the equal cap lengths. Just wondering, is that a Mahindra 2810 or a 3510?

I didn't know the 3510s came with the ML108. Mine has the ML112 and doesn't have the float option. If you haven't found this site...

I'm not sure about a cross reference sheet. I figure as rarely as I would need to change most of those filters I just went with...

Welcome! That's a handy tractor to have. You can get an owners manual here when you put in your Serial#...