Recent content by Ohio RK24

RK24 Boggs down and almost dies under full throttle, occurs wether doing work or just moving tractor around on flat ground. No abnormal noise or behavior other than that, I can move around at lower throttle without problem when trying to do anything that requires higher throttle, it Boggs down...

My RK24 has started bogging down and almost dying at full throttle, any advice.

Great to know, I always have some teflon tape at hand as I live in a very old house. Never a question of if I will need it, just a matter of where. I have in the past used to make up for over sized screw holes in wood. Thanks again.

Thank you for the info, it. is much appreciated.

Howdy folks, I have a quick question about the FEL joy stick on my RK24. It seems that about once every year, I have to tighten up the the nuts that hold the joy stick to the actuator assembly. Has any body ever applied lock tight to the threads before installing the nut to prevent them from...

I appreciate the information, thank you for taking the time to help out.

Thanks for info.

Curious if anyone here has had to prime their RK24 due to running out of fuel, I am wondering what steps would be required to accomplish priming. I guess that I am either not understanding and or missing it in the manual, I have had people tell me that newer tractors should be self priming...

Thanks for the post, I will be doing my fall check very soon, I will give special attention to this are as it appears more than one 24 owner has had this issue.

Yes Sir, Great little tractor, terrible service with undertrained, unconcerned individuals. They probably hire the people that no other tractor service company will hire, I'm sure that they pay is commensurate with skill/ability. Every time I have needed something (which is seldom) they do not...

Let's not forget, a large part of the problem is that is the decimation of our manufacturing base in tithes country. We are dependent upon other countries for common goods in all facets of our society, unfortunately China is the primary source for much of our goods. Between our governments rush...

Glad to be of help.

When I was a kid my step father was a traveling salesman that did demo's for hustler, he would trailer a Hill sider out to potential customers and demonstrate it's capabilities for them. He would often end up going to Dam's and show them how it could safely mow the...

For those that have interest in the outcome of my issue, it seems that the WD40 soaking did the trick, Both the lever and the shift mechanism work freely now easily moving through he range of motion.

Thank you for the advice, did not seem to help in my case, but I certainly appreciate your help. Regards.