Recent content by OhioBruce

I wanted to haul some firewood out of my pasture and felt like some weight on the front would be helpful. My dad had a stack of weights and it turned out that they had slots that matched up to holes on the frame. The weights weigh 10 lbs each, so I've added 50 lbs to the front frame. Will this...

Sometimes I wonder what causes more damage - age, poor maintenance, or previous owners. Yesterday I went to make a drawbar. I found on the forum that there are three holes under the trans that are used to bolt a drawbar to. First thing I did was to remove that plate that was used for the...

My 1110d won't charge. With the engine running I unplugged the alternator (generator?) and used a multimeter to test for voltage and it read zero. I removed the alternator (generator?) and see that it is a permanent magnet type. I've done a little research and I'm confused about if it is an...

Hello All, I just picked up an old Yanmar and hope to get it back in reliable working shape. It's a small one, but should be good to use cleaning out stalls in the barn. Bruce

Hello All, I recently picked up a 1110d and I'm trying to get it in shape to work. The front end leaked so I took it apart to install new seals. The housings were grooved so I installed Redi-Sleeves. I used Loctite 660 retaining compound to fill the grooves and hold the sleeve in place. I...