oldnslo's latest activity

Is the valve accessible? If yes can you install a gauge in the pilot line on the valve section in question or swap pilot lines from a...

Is there a breather tube that goes from the valve cover to intake? If yes then it might be possible to get oil into intake if it is...

Do you have some way of covering or protecting the check block mounting surface? If yes that could be an easier solution since less risk...

Is there some way that you can slightly lift that boom segment with an overhead chain hoist or a jack underneath to relieve the tension...

With lift fully lowered is that bucket arm sitting on a mechanical stop? Looks like it is in picture but not sure. If on mechanical stop...

Your tractor may not have them but is arms on the back of a tractor used to connect implements like a box blade or scraper blade. They...

To size a motor correctly you need desired torque and RPM. Then back figure required GPM and pressure. This usually leads to some give...

Does the loader curl function also shutter if load on the bucket?

Are the electric motor direct drive or is there a V - belt drive? If V-belt What RPM do you want this blade run at?

Have you checked to confirm oil level? Does the power steering work properly? Is the shuddering worse when engine is running at high...

Heating is a symptom of flow being restricted like a directional valve not returning to center or 3 point attempting to raise all the time.

Maybe look at some parts diagrams or if possible a service manual to see how the forward reverse works. Then make a decision based on...

On my 2400H the handle must be all the way down to the floor or the brakes drag a little. I use the brake so infrequently it never...

Is that a feed trough in the foreground of that video clip with skid pulling hay racks? Makes me wonder if just moving short distance on...

Depends on what the OP thinks the dipper is.. Agree on needing clarification of which way the cylinder is moving