Recent content by Orange 08

I seem to be breaking the turnbuckles now and then. How tight should the turnbuckles be on the three point lower arms. A little slack or snug or fully tighten after hooking up to box scraper?

My BX24 can not get the box scraper (Gearmore BB G 54) raised high enough when the top link is pushed out to do some smoothing. From what I read, some of options are to drill a hole further out on the lower link and/or use the quick change attachments. I do not really want to use the quick...

On a tandem axle trailer with leaf springs does the weight equalize between the front and back axles so the front axles don't carry more weight? Do axles with torsion suspension also have a way to equalize the weight?

In my BX24 fuel tank there seems to be some crud that I need to clean out. Probably came from bad bio-diesel. Anyone done this and know what the procedure is?

I am going to change the anti freeze in my BX24 from what I have read almost any kind will do. I am putting in the green stuff. Question is: does anyone know if there is a block drain plug on the BX 24 engine or only the radiaton drain?

I am considering making one of those block walls and want to trailer the pallets of blocks in my dump trailer to save a little money. The trailer of course lifts to dump and it also has loading ramps that store underneath and attach to the rear to load tractor with. I also, of course, have my...

From reading here it seems like I should be using a moly grease. I noticed Kobota or, more likely, the dealer serviced my BX 24 with a grease that was almost clear when I took delivery. Seemed less messy than the black stuff but is it as good? Any idea what kind or brand it might have been...

I have read here the hyd pressure for the BX 24 and 25 is 1849psi and would like to find out for a friend if the BX 23 is the same. We are thinking of checking his also. Thanks.