Recent content by peteinohio

Bought a New Holland 273 Hayliner as part of a multi piece equipment buy. The carrier bearing was shot, one of the yokes was bad and the overrunning clutch had one pin stuck. With the PTO shaft off I still cannot make the machine cycle, so there must be something else jammed. I’m sure the...

I have not tried it yet. I marked the fittings with colored paint before disconnecting anything.

Ptsg see picture and let me know if this is what you mean

There are three lines connected to the tractor. Two from an aluminum block on the left side. One just below and behind the seat. Hopefully I can add a picture showing them.

I’m removing the Bush Hog 2246 from my Kubota L3000dt. In the Bush Hog manual it says “when loader hydraulics are disconnected from tractor the tractor hydraulic circuit must be completed. Failure to do so will result in hydraulic pump damage.” When I connected one of the pressure lines to the...

I did buy the Gribaldi and Salvia unit It did have some broken rock guards and it has many grease points. Parts are available though. So far not a problem.

I could not find the manual using that link but I did find one elsewhere. I bought a model 394 but am having an issue with it fitting onto my Kubota 3000 tractor. The bar that interacts with the chains at one end is dangerously close to the right rear tire. Any adjustment to the left causes the...

I'm in the market for a sickle bar mower and am currently looking at the Gribaldi & Salvia Superior 394 and a New Holland 451. I've been told both are good mowers but that the NH 451 may not fit my Kubota DT3000. Supposedly, there's a clearance issue. Does anyone have any specific info on...

At this point I'm just looking for something that shows the parts with the associated part numbers. I will ask the parts guy when I talk to him as well.

Could anyone refer me to where I could find a manual or illustrated parts breakdown for the Superior 394?

Yes, I see what you mean. I was just out in the shed measurin.

I don’t have what you need, but found your post while looking for an answer to a similar question. Do they make #1 from your picture in different lengths? I just bought a snow blower that came with a 2751 but the shaft is too short for my Bx2370 tractor