I don't have a schematic for the hydraulics but a guy working on it for me does. There is some design changes that have moved valves without noting it. It does only have a single sprocket on the end of the pump shaft. Pump is a casappa 66614680. I did learn from my mechanic today he could...
Also there has been times cracking a hydraulic line or feeling a pressure line there appears to have air or agitation in the system. Can a worn pump cause this effect either by agitation or getting air through shaft seals/bushings? This will make a fellow crazy!
Need some help still on my 2003 DK65 Hydraulics. At RPM below ~1400 you the steering or loader will not work. You can rev it up above 1400 rpm and things kick and go mostly. However you can pull one of the rear remote levers at the same time below 1400 rpm and as soon as you hear the slightest...
I thought I had posted this and was following up chasing my problem. Its a 2003 DK65 that maybe 50% of the time when you first start it after sitting it takes a minute or two for what seems to be the pump to pickup fluid and be able to raise the loader, steer, or raise the 3 point. You can feel...
Hello I had a little incident in which I broke the left lower link arm off the three-point of my tractor. It broke part of the rear housing that extends down where the pin goes through the link arm
Can anyone tell me what type of metal if it is cast-iron or cast steel and how difficult it is...
Thanks! Been searching high and low online but all I can come up with is the manual type that has a 90 lever like this Manual Hydraulic Multiplier, SCV Splitter / Diverter Valve Kit with Couplers, NPT
Most are going to solenoid types for use with cabs but in my case I'd rather have a simple...
Wondering if any of you can steer me to who makes these. I was looking at a John Deere baler today at an auction and the baler had 4 hoses running into a multiplier or divider mounted on the baler tongue with a pull rope which would run to the tractor seat. I suppose it was some sort of ratchet...
I know there have been several post related to this subject but I just broke mine for the second time in 300 hours, actually 3rd time but this latest was from having it welded after the second break. The part number shows to be 35270-16600 and several post have gave alternative parts to use...
I've had my cutter probably 5 years now and short of some general expected stuff it has worked without a hitch, not used a lot but I have cut 5 acres of hay on occaision. Now this year when I went to using it the machine seemed to be making a chattering like noise and broke the sickle knife head...
Its hard to explain but the hydraulics do not seem that smooth from the power steering to the lift arms. Vibrations, catchiness, etc.
Today while running the pto on a sprayer the power steering was almost non existent, very hard to steer. I've noticed this when running other equipment too with...
Lets see how hard this is to explain.
My 585 at random times while say running the PTO will all the sudden become hard to steer like the pump quit working. It becomes very jerky or sporadic at best. At the same time the pto begins to stop powering the implement. Basically the only remedy I've...
Guys, I have a rhino backhoe on a 30 horse Kioti tractor. The backhoe has an external pto pump/reservoir. This weekend while using it to dig a trench for a friends outdoor furnace lines I blew line after line. Lets see...I blew 6-7 lines in the 2 days and 75 feet of digging. Both lines on the...
Guy,
Up until today my Kioti seemed sort of eratic on how accurate the gas gauge worked and the back tail or brake lights would stay on without any light switches on. I think the light situation is due to some wires that got disconnected.
This afternoon after running it for a bit I went back to...