Recent content by poppey

Hi I intend to buy a plasmacutter and see that there are units like this. Anyone having experience with the 3 in one units? Today I only have cheap stic welder and would like a TIG as well. Simadre Plasma Cutter Foot Pedal 5200DX 50A 200A TIG Arc MMA Welder 110 220V | eBay Its only hobby use...

Milling gearbox end covers.

My project is going very slow. Have been bussy with other stuff but the gearbox is soon ready. Here's a few pics.

Hi I have a second hand Kubota K0008 that was supposed to be from 2000. The belts are not adjustable so I have cut and welded in a square tube each side to widen it 300 mm (12 in). It has say about 2000 hr, it run well and is perfect for my use. I is yellow today but original it has been light...

Hi Here are the design of the rear gearbox. To reverce the rev, I have put in a set of spure gerars Metric module M3 Z40 and further chain and sprocket #60. Than the rev should be correct. I,m putting the drive inside a rectangular tube 150x100x6. The first two images shows shows the drive...

The front lift is getting ready. Hydraulic hookup and painting left.

Hi Thanks a lot. I have been thinking about re checking the rotation. Thanks a lot for this valuable information.

Details of the cylinder lift arm.

Details of the cylinder lifting arm.

Did some machining today.

I have a Kubota BX11860 and have started planning building a front mounted snow blower. Have ordered the gearbox, 3 point hitch kit and lift cylinder on e-bay. Design is getting close but still some details left. I not in a ruch and is not heading to get it ready to handle this years snow. I...

Hi I have a Kubota BX1860. Anyone know what the hyrdraulic pressure is? Relief valve setting.

Hi I have 0.6 ac and about half of it is lawn. It is getting a bit bumpy and I would like to level it. I have JD LT180 lawn mover and just boutght a new Kubota BX 1680. I was supposed to use the BX 1680 mover but I found it a bit big so I have stored the mover deck away. But uses the loader on...