Recent content by porkinbean

  1. P

    NX5510 - No hydraulics after filter and fluid change

    Check for external filter inside the hydraulic tank. Should be acessable either where the fluid line exits the tank!
  2. P

    need to flush hydraulic cavity on john deere 5055 E

    Problem found. The debris is from the brake assembly. Had a mechanic look at it. Estimated repair $1000. Ouch!
  3. P

    Hydraulic problem Jinma 284 eng.y385 bucket will not lift no power steering

    not familiar with jinma but my john deere is having the same problem. see if there is a filter screen in the sump area. if it has a screen filter then it is probly plugged. the hydralic fluid has to go through the screen before it goes anywhere else.
  4. P

    need to flush hydraulic cavity on john deere 5055 E

    This is the large piece that i found.1/16 thick very thin
  5. P

    need to flush hydraulic cavity on john deere 5055 E

    this is a picture of the filter screen. I have a picture of one large part of the fiber on my phone but it did not transfer. I will try to upload it.
  6. P

    need to flush hydraulic cavity on john deere 5055 E

    I just recently aquired the tractor from a family member. he said the tractor had been setting up about 10 months. I think it was a lot longer than that. when i got it it would not run. Had to replace the fuel pump. then the hydraulics were very jerky when operated. I drained the fluid and...
  7. P

    need to flush hydraulic cavity on john deere 5055 E

    My suction screen on my hydralic system is plugged with some debre and i need to flush the system. how can i do that and what is best to use to do that.
Top