Extra auger shearbolts and extra blower shearbolts
with the wrenches to do the job inside the aluminum box tubing. Now I have the tools with me
at all times and can easily check shearbolt inventory.
I need help! Has anyone removed there driveshaft from a BX?
I ran a stick up under the tractor and it went and tore the rubber boot around the CV joint on the rear of the shaft. Just missed the cooling fan for the hydro unit. I have the front and rear CV joints unbolted but it wouldn't come out...
Bring on the weeds \"Homemade Sprayer\"
Always needed a sprayer to do the fence row and spot spraying.Got tired of walking with the backpack sprayer, so here is what I came up with. Found a RV water pump at a yard sale for ten bucks and the rest of the stuff I had. Then so I could spray from...
After using my loader at night I knew I needed some additional lights, but just could not come up with the setup that I liked. After much reading TBN I realized there are several ways to skin a cat and mount lights.
I used arc welding magnetic grounding blocks and mounted my lights to them and...
Needed to make some room in the garage so i got the MMM off the floor. Had a small block and tackle not being used so i
hung the deck. Also makes it easier to clean and service. Next a dolly frame for the FEL.
Can anyone tell me why Kubota says not to run rear wheel weights and filled tires at the same time? I have a BX2200 with FEL and wheel weights but need more ballast to do FEL work on side hills. Dan