PowerTracManiac's latest activity
-
Terrible idea. If you can trace the wire connected to the fuse from a to z, then eliminate it and run a new wire with a fuse. By... -
PowerTracManiac replied to the thread Power Trac in Western NC?.All issues diagnosed/resolved over phone with Terry at PT factory and parts sent directly to me. Very reasonable costs for the parts...
-
Disconnect the wire in question and run a temporary bypass for that wire (don't run through the tunnel) and see if that changes...
-
If it's blowing a fuse rated 10 amps higher than the breaker, you have a wire that is grounding out somewhere, it is pulling too many...
-
PowerTracManiac replied to the thread Power Trac in Western NC?.Saw this post and though you might find it interesting. https://www.tractorbynet.com/forums/threads/pt-1845-pt-1850.57040/ When I got...
-
PowerTracManiac replied to the thread 1845 problem.. ***yes to above*** You started this post with a mouse nest in the engine bay. I bet they also chewed up some wire insulation...
-
Been using an old grinder wheel (teeth welded on) and the carbide inserts were broken off most of the teeth. Needless to say the old...
-
-
Thought I’d change the oil after eighteen years. Putting aside all the debate on motor oil vs hydraulic fluid. I ended up somewhere in...
-
PowerTracManiac posted the thread Anybody going to PT from the Mid Atlantic area? Need Stump grinder picked up. in Power Trac.I had a truck when I dropped off my stump grinder for work and now only have a small vehicle. Not big enough to get the stump grinder. I...
