Hello
Hello,
I recently purchased this flail mower but it is not totally right for my tractor. I wanted to find out if the alignment of the PTO drive shaft is OK to be about 3-4 inches off alignment from the center line of the tractor PTO shaft? I was thinking of welding new mounts on the...
Thanks Lenoz for the information attached are a few pictures you requested.
The rear roller is at work one of the bearing was shot causing the significant damage to the shaft. I am turning a new shaft and have replacement bearing on order. I have the other parts you mentioned except for the...
Attached are a few pictures of the mower I have.
with the PTO speed at 540 rpm I get a cutter speed of 750 rpm if I change the PTO speed to 742 rpm the cutter speed is 1000 rpm. this gives a ratio of about 1:1.4. I could change the bottom pulley to about half the diameter to get the cutter speed...
Hello,
I just joined your group and recently picked up a Mott Flail mower with fine cut blades.
I am interested in hearing any suggestions and getting advice from users of this type of mower.
I tried the mower out when I got it home and it shoots grass out the front of the mower. I believe is a...