Recent content by project_X

Can't see to find any of the usual suspects of bar tires for ztrs that will fit. 23 10.5 -12 Anybody have any luck?

Any one seen or used a Range Road Chipper...RR415 or RR420? They seem eerily similar to the Woodland Mills Chippers.

Hi all, I purchased a used quick hitch for my B3300. I'm interesting in the mounting of the plate that holds the pin for the rear of the mount. I have two brackets, but the pin looks to align with the bottom of the loader mount...I have found pics for just about every other arrangement...except...

looking for the part number of pby sleeve for jd 8 backhoe. The dealer's parts guy asked me what power beyond was... needless to say he wasn't much help. Thanks, Rob

So I need to pull the clutch and adjust the bolts 11 in the following diagram?

Hi all, I happen to be an Orange tractor owner that needs a loader. Since my tractor is a vintage 1980s L235dt, I needed to fab my own mounts. I came across a cheap 200cx with 2305 mounts. Could someone measure the outside width of the vertical arms of the mounts and the height to the ground to...

I adjusted the clutch play, it is now less than one inch. The gap is much smaller, but it is not close to touching. I'm beginning to think that the clutch never worked...and when I tested the pto, I didn't put a load on it.. Any ways, I will continue the adjustment to see if I can get it working.

I picked up a used l235 with 400hrs. In looking after the tractor, I changed all the fluids to get a baseline. Prior to changing the fluids (specifically the transmission/hysraulic fluid), the live pto functioned correctly. Now, I can not engage the lever, and if I engage the lever, the clutch...

just because I haven't spent enough time working on my hydraulics this summer, my loader lift cylinder decided to start pouring fluid out of it. I ordered the rebuild kit from koyker, and will pull the cylinder apart tomorrow. Are their any trick or tips anyone can suggest to help me along?

I post this in the hydraulics thread, but thought some Yanmar-centric ideas might help. Arrgh, three point hitch lifting no weight

As you may have seen, I have added a set of rear remotes to my 1602D yanmar and everything has been tested; loader, 3pt hitch and remotes without any problems. Symptoms: Today, I was finally getting to moving some earth with my box blade, everything worked well raised/lower 3pt hitch on...

I am looking at fabbing power assist for my Yanmar using the valve from a 400 lawn tractor or 950 (AM35449). I can see parts of the assembly of the valve and cylinder on JDparts, but could not find exactly how they fit on the tractor. Does anyone have pictures of the power assist on either of...

Does anyone have power assist steering or power steering on their Yanmars? If so, could you post pictures of the valve and the cylinder positioning? I want to add it to my 1602D, i've seen the kits available as retrofit, but I was hoping to fab my own to save some $$$. Thanks, Rob

I have a 1602D that has a loader installed as most grey markets by cutting into the high pressure line. I wanted to add rear remotes to add a hydraulic top link and a hydraulic cylinder to raise my sickle mower into transport to get around some obstacles... After reading the threads of...

I'm looking to finally get my remote hydraulics installed on my Yanmar, and need to finalize a valve. I have access to a Eaton 31920-CCW. Will this Valve do the trick? Here is a general PDF on the series of valves and a pdf of the info the valve itself. Eaton Control Valve 31920 CCW Specific...