Lots of changes in the last couple years - I am curious what you guys recommend for a grapple for the BX series. Obviously it doesn’t have a lot of lift so it’s gotta be lightweight but needs to be tough enough to survive. Anyone have thought?
How can you adjust charge pressure or anything to give the rtv1100 a little more power to the ground? It will not climb hills in anything but low and pulling a small trailer it simply cannot back them up a hill? Seems like the hydro trans really should bite hard enough to bog the engine- no luck...
Does anyone know how to adjust the loader stick lock on the BX23S? When they installed the third function, the lock is 1/8"+ (or more) from aligning to be able to engage. Since I don't mow with the loader, it would be nice to lock it out so I am not bumping it while happily bouncing along.
Just finished the complete 50 hour oil change on the m7040. A ton of material in the hydraulic oil. I am hearing that is typical for the first oil change. If it was engine oil on a car I would swear the bearings were gone, the oil was shimmering silver. Is this really the norm?
For starters I have an M7040 with shuttle shift. I have noticed that when cold the tractor running in neutral will jerk back and forth. It seems to be the hydralic pump until it warms up moving teh tractor. It jerks worse with the tractor in gear but of course the shuttle still in neutral. Pulls...
Who has the best prices for the 50 hour service oils and filter (M7040) at this point? I have a few hours before it hits and it seems that mail order is usually a better route for supplies.
I am looing for a set of pallet forks for an 1153 loader. Complete setup, frame and forks. Anyone know of a good buy or possibly an aftermarket one that fits the quick detach on the 1153?
Easy stupid question...
What is the "button in the center of the lights/turn signal switch selectors? It looks to be ... well ... a button, but I have yet to find it doing a thing... Have I lost my mind? is it just the center of the switches? I thought it may be a horn but I dont think the...
Although I hope for many trouble free years of service I strongly believe in having a good manual in case you need to turn a wrench on the unit. Where can I find a top notch manual for a M7040. Id pay for a factory service manual if I can find one...
Who has had any dealings with internationla technologies rotary cutters? It looks like they are extremely well built for the money. I am looking for a 7 ft and there is no comparison for price vs construction.