Recent content by pvcman1

Have a new holland workmaster 55 and i am having problems with the gauges and indicater lights working intermitantly is this a ground problem and where would i find the ground wire? Thanks

Hi, Having problems with my speed gauge and fuel guage not always working they sometimes come on and work then when you turn the tractor off they stop working and then work again when they want is this a eletrical problem?Also my indicators do the same thing.Thanks

Hi,Does anybody have one of these rakes/tedders, I am looking at the best way to use one.Are they any good for tedding with?Should the wheels be in the down or up position and should the tines be on a steep angle for tedding? it doesnt seem to throw the hay and spread it out much.Do the tines...

cost was $80 in canada

rc sixtyeight you were correct it was the fuel modual,when i wiggled it the tractor would stop so i have wedged a bit of wood under untill i can get a new one Thanks again.

Thanks i will have a look at that,today it stopped twice and then ran all day,tomorrow it will probably stop again

carnt see anything that is but i may have to take hood off to get a better look, i did wonder if a electrical wire could be rubbing making it stop?

After it running for a few hours it will just stop and have just found that when the hood is up it will start and run but when the hood is put bk down after a few minutes or seconds it will stop or sometimes run all day ,it then wont start untill the hood is put back up,anyone else had the same...

Done the filter and taken it out but still stops.The tube from the fuel pot to the injecter has gaps maybe bubbles would this make the tractor stall?

Hi,I have a new holland workmaster 55 tractor and it was working fine untill it has started to cut out and stop. It will run for a while and then stop sometimes it will run for an hour then stop it then sometimes will start and run again for a while or it wont start at all unless its left for...

It has a 3pt but the rake swivels on its frame

Hi. i have a pz 2000 belt rake and in the instruction book it says there is a vertical check chain to stop the rake from tilting when raising the rake does anyone no where this is and where it would fasten? i carnt see anywhere it would be.Thanks

Hi, Have a international 46 baler with pick up clutch problem,pickup wont turn hub just spins so i think it needs new linings at the momment carnt get hub off probably rusted on, wonderd if i could drill a hole through hub and cog and use a shear bolt instead of new linings?

Hi,i have a international 46 square baler that has a problem when baleing on uneven ground.The hay pickup does not have a pickup wheel and stops tuning when the tines hit the ground, does the pickup wheels help this problem? as i carnt buy a wheel and brkt i may try and make one if helps. thanks

Hi, going to be changing the transmission oil on my international 434 tractor,the info i have says it needs 4 3/4 gallons of oil does this sound right? also it says fill up to oil level plug does this mean it will be filled nearly to the top? Thanks.