I probably edited my post when you were replying.
I added that pic of actual setup - working and what I could do to use the PB and protect Tank side of BH valve
Well I just looked at the schematic of my valve and the PB port sleeve is optional. Otherwise, there is a plug (#8 ORBM) that seal that port. Both the Tank and PB hoses comes from the same 'block' of the valve (modular valve). Both are also the same sizing so given that I'm pretty sure the Tank...
Hi Ericm979, thanks again for your help, i'm getting there !
Ok so here's what I would do then:
Tie the BH hydraulics AFTER my current remote stack, so outlet 'T' from the remote would feed the BH pressure line (RED - P), then the BH PB hose (the blue one I guess since the yellow is the Tank...
Hi Guys,
I'm a bit 'new' to the tractor scene so I think I'll need help from hydraulic gurus here.
I have an older Oliver 550 (gas) tractor. Manual trans (not hydro) with hydraulic output for my FEL and Snowblower (chute)
The setup I have currently works fine. I have a joystick up front for...