Recent content by Rayrla

Thanks to all for the responses. Looked at seats at Amazon, various other online sources, and even places north of the border. Even thought about getting the seat reupholstered. Only problem with seat is vinyl cover. Solution finally fell into my lap literally. While cutting my front ditch, I...

Fantastic thread! This thread and several others should be grouped under required reading for first time tractor buyers.

The very reason I asked for feedback from owners who have purchased replacement seats. The ones I have seen don't look like they will hold up very well on an open station tractor. My old seat will be 30 years old next year and seat surface started splitting a couple of years ago.

Time for a new seat on the 1920. Would appreciate any feedback from other Ford series 20 owners who purchased an aftermarket seat. Thanks.

/pine has made some very important comments regarding maintaining golf cart lead acid batteries. I have a 2006 club which came with 4 12 volt batteries which were very short life batteries. Very poplular with the 4 12volt battery Club Car owners was a change to either 6 or 8 volt 48 volt...

After approx 20 hours of use found a puddle of hydraulic oil under my new Ford 1920. Found power steering hose(if memory serves me correctly) rubbing against a pulley.Called dealer for warranty service. Sent UPS new hose, oil and a zip tie with instructions to repair. Over 25 years later...

Last hydraulic oil/filter change( 2 years ago) on my Ford 1920 there wasn't any G134 at my dealer. Parts guy said they were now supplying Kubota UDT or SUDT(can't recall which) in place of G134. Had filter just no G134 and none on order. All information on Kubota/New Holland/Deere hydraulic oils...

Don't use the backhoe very much. Considering purchasing 4 foot cutter to use. For those B26 owners who use a brush cutter, what has been your experience. Thanks for the feedback.

Used the B26 to dig a trench for a 20 foot culvert to divert water under my driveway and spread a load of maintenance gravel. Time to complete these tasks was about 3 hours. Tractor performed flawlessly. Parked tractor for about three months and then tried to start with no success, just a click...

Anyone have a suggestion on an aftermarket 3 point hitch system? Thanks.

Still trying to fix all of the problems with my newly acquired 2013 B26. Tractor idled low and high very good but would stall in forward L, M or H and reverse. My problem was with the seat safety switch. It was just dangling under the seat completely wrapped with electrical tape to close the...

Recently purchased a 2013 B26TLB which comes standard with the loader quick attach. Having trouble releasing the bucket to remove. Loader quick attach handles just won't move to up(Release) position. I am following instructions in the manual. Appears bucket may not have been removed in quite a...

My Stihl 026 has a fuel supply problem. When I pour some fuel directly into the carb, it runs for a few seconds and dies. I have removed the carb, the fuel line, and filter. I plan on purchasing a rebuild kit for the carb and new fuel line and filter. There is another line from the carb that...

I hope some of the 1920 experts in this group will be able to provide some assistance. Over the last two years I have noticed that my coolant level goes down slightly and I have had to add small amounts. The amounts have been increasing. I have found no leaks but have noticed white smoke from...

First I would like to thank all who have posted their FEL snow plow projects. They have been an excellent source of information and ideas, as well as inspiration to start my project. I hope that this post will also add to the knowledge and idea base. The goal of my build will be to fabricate an...