Recent content by Rays Mahendra

Here are the pic's. You can see where the bolts backed out and would not let the motor turn. Just need to put it back in time, and reassembled.

UPDATE 3 Flywheel bolts backed out into the clutch plate and would not let the motor turn. Screwed the bolts back in and now the motor turns with a wrench. (will sent pic's later.) I am wondering how to get the motor back in time. Everything was fine until the only gear with no key way fell...

Just started to tear it down... The valves in the first cylinder one open, one closed. The second cylinder both valves are open. Third cylinder one open, one closed. I am not sure if both valves on the second cylinder should be open. The motor is not at top dead center. (its locked up) Taking...

Yes, it will cost 16-18 Thousand dollars for the block, crank, pistons etc. also labor, almost what I paid for it back in 2014. I may have found a motor on e-bay for 5,000-6,000. I need to make sure the trans will fit. Thanks for the info

Someone borrowed it and didn't check the oil. :(

I am look for a motor for my Mahendra 3016 3 cylinder, 28hp, 1.3L, Mitsubishi. The motor is locked up. Thanks for any information.