I use a FIMCO 40 gallon that attaches to my 3 point. Bought it from TSC. I also added an extra 50' of hose so I can park the tractor and use the wand sprayer farther from the tractor when needed. I didn't think I would get as much use as I do from it but I use it a LOT.
I know this may be confusing but I have tried to make it as clear as I can.
When I bought my used 4025 tractor a few years ago they included a post hole digger. Well yesterday I tried to connect it to my tractor for the first time. The PHD needs a Cat 0 pin. The existing top link pin is...
While brush hogging today I thought I had fell in a hole but it turned out the front left wheel had cracked in half (not vertically but completely around the rim). I can see what appears to be a long time rusting crack where it fell apart. I can replace the wheel and tire but the one that came...
This is all new to me... Since the land I'm clearing (Texas) doesn't have a home on it (or power or water or barn) my current insurance company will not offer me coverage for my equipment (tractor and excavator) and will only add liability coverage to my existing homeowners policy. So no help at...
Was digging stumps at full power and after about 30 minutes the engine RPM dropped to idle even though the power was turned all the way up. Could turn the power knob down to idle and back up and the RPM would increase for about 5 seconds then drop to about idle speed again, even though the power...
We bought about 25 acres in Nocona, Texas that has never been cleared so I have my work cut out for me. I bought a used Mahindra 4025 and a used Bobcat E35 mini excavator to help get the work done.
Steep learning curve for me. The tractor seems to have been fairly well maintained but the...
Mahindra 4025 clutch not completely disengaging
I have been lurking in the forum for quite a while and finally decided to register. This is my first post.
I bought a used Mahindra 4025 2WD a while back. At this point is has about 450 hours on it. When I depress the clutch (dual clutch) and go...