Recent content by rbento

I did my research on TBN and here are the results. I am very happy with the work output, actually amazed. Thw whole project cost less than $1,000Thanks to all at TBN for the info:)

I am adding a grapple to my FEL on my kubota b21. My question is... to get pressure to my new grapple valve should I go from the pump pressure line to the new valve "in" then out via PB to the FEL valve "in" ? or should I tap into the FEL PB to get the pressure to the new valve then out via PB...

I have been doing a lot of reading here on TBN and I am starting to get a little less confused, Thanks you for that. Now it is time to by the hydraulic valve and hoses. By the way I have a Kubota B21 TLB and I purchased a Tatro grapple for my FEL. The grapple came with a cylinder Model 218-298...