Recent content by Rdr202

I've had good luck using Simple Green concentrate a power washer and scrub brush. Hit oil stain with Simple Green let it sit for five or ten minutes use brush to scrub stain then use power washer .

Just use a basic lever Get a 4"x4" x 10' Board and a good size rock and use it to raise up one corner at a time and place some cement blocks to hold it up level.

Yes

I had 3/4 acre and I had a Mahindra eMax 22 with loader and backhoe and I also had a Husqvarna Garden Tractor with a plow blade, a Craftsman lawn tractor with snowblower and soft cab and a Craftsman lawn tractor with mower deck and leave vacuum Cart. sure over kill

Was using my eMax22 after shutting it down and restarting I heard a loud pop like a fuse blowing. Checked all the fuses looked for a short couldn’t find anything. Checked battery it was reading 12.34v then I noticed battery was leaking. Replaced battery and started right up. Battery was only...

Video I made on removal of strainer on emax22 HST Mahindra Emax22 HST Suction filter removal - YouTube

Made this video showing the 50 hour service. It's far from perfect video but it may show a new tractor owner that the job is not that difficult if they are on the fence about doing the service the self Mahindra eMax22 50 hour service - YouTube

Noticed yesterday the wire under the seat that goes to the safety switch was crushed and the covering was all frayed. From what I can tell when you move seat to use backhoe the wire gets pinched in the seat frame. I put some eclectically tape over the area, then I wrapped the wire with an 8"...

I have the old style 26 b that I added a thumb for moving rocks.

I just installed a thumb on my backhoe. I went with the Mahindra factory manual thumb for my eMax22. I had considered an after market bolt on thumb on Amazon cost was under $200 but thought the factory one was a better fit and worth the extra cost.

I mounted a grease gun holder to the FEL control valve bracket and then mounted a small plastic toolbox to the ROPS.