Recent content by Redlander

Thank you Jeff, (Winston). This below is what I'm looking at. I'm just looking for some guidance choosing between widths of 4' and 5' (it also comes in 6') What works for others. The advert says from 20HP to 40HP. 5ft "S" Tine Cultivator

Would a Yanmar YM2610D pull a 4 or a 5 foot 6 or 10 tine S-Tine Cultivator? I'm pleased with the performance of this little tractor with a 5' slasher and with an 8 disk 4' offset harrows . However before I buy a cultivator for it I'd like to hear what someone else has to say. The ground is not...

I need help please. Last year a forum member kindly sent me a workshop manual for an almost identical tractor, YM276D However I can't seem to find any info or where to look ... what may have caused the tacho/hour meter to stop working Cheers Bob (Redlander)

I had just charged my battery, started the tractor first go, then backed out of the shed Silly-me misjudged the shuttle shift and put on the brakes while still in reverse gear, and stalled the engine When I went to re-start ... nothing ... dead ... no panel lights even Before I start pulling...

Yanmar YM2310D at "Red Rose" Taabinga (high on the Great Dividing Range) Queensland Australia

OK, here is the sketch of the piping And on the manifold I found a painted-over plate "DEU-YN" "P-1285-03" Levers 1 & 2 are the FEL controls - all OK Lever 3 must always stay `Down' for ANYTHING to work The Ball Valve 4 needs to stay open for the FEL to work With it open the TPL does not work...

The valve is fed from a tee that brings in fluid from the case The hose from the bottom leg of the tee loops up and enters the manifold at the third valve

And this is the valve manifold The mystery valve is on the extreme right hand side in the picture Beneath it inline is the ball valve that needs closing to activate the TPL `lift'

This is the tractor with what seems to be an original front end loader Let's see if I uploaded this correctly

I am a new owner of a Yanmar 2310D with front end loader Everything has been working just fine But today after doing some heavy lifting the loader has lost its controls (I assume the PTO also has lost power) The oil level in the box has fallen below the low tide mark I have found a small leak...