Recent content by Redriderjr326

Not a chance I’ll get this to fit with the current start that is on there.

So I ordered the 1 heater that is generally recommended for 3 cylinder yanmar engines and it is way to big for the plug I was referencing earlier! There is what appears to be a freeze plug next to it, just wondering if I should use that with a different style heater? I壇 rather thread it in there...

Sorry to revive an old thread but I cant find an answer any where else. I want to install the block heater as described in this thread, however, in my 3110d there is a hose coming from where the plug should be and runs down into another fitting. Any ideas what this hose is for? I cannt find any...

Timberhole; when you used that sleeve, were you able to use the original sized seals or did you have to use something else? I pulled the left side off and found I need to sleeve it....among finding all the bearings shot in that side...:thumbdown:

Yes that is correct. They pumped everything full of grease. They put bolts with zerks anywhere the drain bolts are. The area where I replaced the seals wasnt really too full and is clean now. The portion of the gear box that the rim bolts onto can pulled apart. Maybe I should do that to clean...

I have a Yanmar 3110d that has the old style seals in knuckle. There is lots of info on the new style but I can稚 find much on the old style. There are 2 seals that are suppose to go on. When I pulled it apart I only found 1 seal. Do both seals go inside the front lower gear box (#2)? Or point...

Hello all, 1st post, however have read many posts regarding different things, thanks for all the information. Last fall I picked up a 2003 Husqvarna Rider 155. Didn稚 know much about them except that I knew I loved the way they mowed. Found me one a couple hundred miles away and bought it for...