Recent content by rickdavis81

Any one know the part number for a 2510 cross shaft u joint? Moog or standard replacement?

Can’t believe I didn’t catch it saying international. I’ll see what I can find when I go look at it. Thanks

Looking at older smaller 15-20k lb track loaders for a little work on the farm. Found a Cat 933. Owner isn’t much help with info other than saying runs good, no leaks and under carriage is good. Can anyone tell me what series it might be? Hp? Pain the butt to find parts or run? Any other...

Thanks. I’ve been waiting to hear from someone who has their cutter.

Looking at an Allis HD7G. Any good sources for steering clutches?

I’ll have to see if I can find one close to inspect before I order one. Sounds like they may be worth a shot

Anyone use one of their rotary cutters? One friend told me about their 10’ mowers and the price is less than a good used Deere or Bush Hog. I was questioning their quality but another trusted friend said he had experience with their 3 point blades and they were stout. His opinion is pretty much...

I realize it has to telescope. Maybe I’m not asking the question properly. I’ll try it with the longer single pto shaft assembly and see how it does. If it vibrates or comes off and beats the heck out of me then I’ll switch it up.

I picked up a Woods C114 10’ cutter last fall. It was missing the pto shaft. Looking online it appears it had a 2 section driveline with possibly a carrier bearing in the middle with a shorter shaft attaching to the tractor. I’ve seen several setup like this. But I’ve also seen a few with just a...

It crossed my mind for the road grader job but I don’t need everyone on my butt all the time. And between a 60hr a week plant engineering job, gun shop and starting a trucking company I don’t need another job lol

Neighbors and I all have nice new houses and pay dearly in property taxes. It’s irritating

No pics. At work at the moment. I’d say 98% dirt and the gravel is small road rock. Usually the grader operaters just smooth it back onto the road and we get flats for the next month or so around here. I set my side linkage so it cuts more on the outside and then after a couple passes I wind up...

After advice on here I purchased an EA land plane to maintain my mile of gravel road. Does an amazing job. Talked to the road grader and he cut some of the ditches awhile back to help where they had filled back in. Should I blade the dirt/rock mound on to the road and smooth it out with several...

That does look like it, thanks. I think someone removed the original cylinder

Anyone know the model of the cutter I picked up today? I’m pretty sure it’s a Woods. It’s belt driven to the spindles and they say Woods 15184. Ordered new belts because they’re splitting. It’s 10’ outside to outside. Need to replace the tires if anyone has recommendations on what to get. One...