Recent content by Riddler

Thanks a bunch. This guidance will help me alot when I finally dig into the machine this week.

The D100 is a nice machine. Thanks for the lead.

Any idea where the solenoid valve might be located on the machine? I can’t find a solenoid valve listed anywhere in the parts manual for this unit.

I just purchased a Boxer 525dx mini-skid steer with 950 hours that has a hi/low switch that needs to be set in the “hi” position for increased ground speed when traveling, or for maximizing flow to a trencher or auger. The hi/low switch summary from the operator’s manual is attached. The...

Would like to buy a hydraulic hose crimp tool for occasional use in my equipment barn. Any advice regarding brands, features, etc.? Do the manually operated “no-name” units in the $800 range work well enough?

Thanks so much for all the detail, especially the photos. Super clean OEM-style look.

Need to add rear remotes to my Kubota L3130. There is no loader or back hoe on the tractor, and likely never will be. The two pages of the Operator’s Manual that I have attached below say that I should be able to plug my hoses into the hydro block underneath the right footrest by simply...

I have a small NH 105A tiller. I'd like to know the fill level for the case on the side of tiller that houses the chain and sprockets that turn the tine shaft. The plug at the top of the chain/sprocket cover has a description that implies that the cover should be filled to within 3/8" of the...

Looking for help to reinstall the chain tensioner arm and spring on a 40" NH 105A tiller. The arm and spring were removed to replace a broken spring, but I am not 100% sure how to reinstall the the assembly correctly. A photo of what the reassembled arm and spring look like would be perfect...

My TN75VA stops running or won't rev past minimum after operating normally for a period (e.g., 30 minutes). Often, just before the engine quits altogether, it suddenly drops rpm to bare minimum and won't respond to movements of the throttle. Then, after the engine dies and won't restart, we...

I am looking to process/dispose of prunings in place from 20 acres of grapevines. One option is a specialized flail mower/mulcher designed to pulverize prunings while mowing a permanent cover crop between the vine rows. As another possible option, I'd like to experiment with a...

I'd appreciate a pm from anyone who knows of someone in the West Sonoma County area who can perform routine servicing of my tractors, and diagnose problems when they come up, on site. It is difficult for me to transport them from the property to the shop and back everytime they need something...

Does anyone have first hand experience with the following adjustable width (5'-6') tandem disc: TANDEM DISKS | VT THREE-POINT PIN ADJUST NON-REVERSIBLE TANDEM VINEYARD DISK or Gearmore - Tandem Disc 3-Pt. GV Narrow Row Series - Tandem Disc 3-Pt. GV Narrow Row Series The Gearmore unit...

Anyone know of a cost effective substitute for the OEM rear shock absorbers on a 2510? I have a hunch that there any number of ATV or motorcycle shocks whose dimensions, travel, dampening rate and bolt holes are close enough to work just fine on a 2510. The OEM units are $120 each, which seem a...

Looking for a used transmission for a 4WD New Holland TC 18. Feel free to private message me.