Recent content by rnds76b

Sometimes it takes my little brain a tad longer to see the light, Harry. As i was reading your post, it just dawned on me that all I should have to do is detach the front end of the brake rod from the lever, THEN unscrew the rod from the turnbuckle to get it off and remove the boot. As the new...

Have loosened/removed the retaining plate around my 2008 Mahindra 4110 rear brake boot (where the brake rod goes into the rear axle), but don't know how to "break" the rod apart to get the old boot off the rod and the new one on. Anyone done this and have any advice?

Hi Dave...hope you're still around on this forum...I'm changing the rear brake boot on my 2008 Mahindra 4110. Got the retaining bracket off OK, boot is loose, fluid has drained out, but can't figure out how to get the old boot off the brake rod and the new one on. Tried separating the rod at...

Everyone...thanks so much for the input & suggestions! Unbelievably, over the past few months, the instruments I spoke of that were not reading correctly, have gradually returned to almost normal. Qs you've all indicated, I'm fairly certain it's a grounding problem...just haven't had the...

Thanks guys...good idea...will run a separate ground soon & let ya know....

Thanks Duffer...your comments renew my intent to re-trace all the wires.

2008 Mahindra 4110 diesel tractor. Recently noticed that my engine oil temp needle was registering between the bottom and first mark on the gauge. Normally registers at the 1/2 way point on the gauge (third mark). Then noticed that my RPM needle wouldn't go above 15, when it's normally 25...

Does anyone know if a Craftsman 486.248260 Snow Thrower attachment will fit on a Craftsman 917.287251 DYS 4500 Yard Tractor? Or, how/where I could find out from Sears, etc. Thanks!

Will a Bradco 11HD Backhoe fit my Mahindra 4110? And/or is it heavy enough/too light for the tractor? The used one I'm looking at has a PTO driven hydraulic pump and attaches to a sub frame on a John Deere 5300. Thanx for any advice.